Craftsman 137.224320 - Manual (Page 10)

ASSEMBLY AND ADJUSTMENTS
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED
«ED ^ i ‘ r * I ‘ I ' i ' I
l-A I iJ
Phillips screwdriver Combination square
T“* I ■ I ' I '' I' 1' I' I' p
• Adjustable wrench
I I I I . i I I .'I , I , I . t ,'l ,-TrTT
Straight edge
Feeler gauge - size 0.02
A WARNING
For your safety, never connect plug to power source
receptacle until all assembly and adjustment steps are
completed, and you have read and understood the safety
and operating instructions.
LEG STAND ASSEMBLY (FiG. A)
1 .
2 .
3.
4.
5.
6
.
Lay the top plate (1) upside down on a flat surface.
Attach a leg (2) to the outside of the stand top plate with
four carriage bolts (3), washers (4), and nuts (5). Do not
tighten.
Repeat for the remaining three legs.
Attach two long brackets (6) and two short brackets (7)
to the inside of the legs, using carriage bolts (3),
washers (4), and nuts (5). Do not tighten.
Place the leg pads (8) on each leg and turn the leg
stand upright on a firm level surface.
Adjust the stand for stability.
A WARNING
Although compact, this saw is heavy. To avoid back injury, get
help to lift the saw.
ASSEMBLE BAND SAW TO LEG STAND (FIG. B)
1. Lift the saw body (1) and place on the leg stand (2),
aligning the mounting holes (3) of the saw base with the
four mounting holes of the leg stand top plate.
2. Attach the band saw to the stand with four long hex head
bolts (4) and four flat washers (5).
3. Place a flat washer (5) and hex nut (6) on each bolt from
the underside. Hand tighten.
4. Tighten all mounting bolts and nuts with a wrench.
5. Tighten all leg stand bolts and nuts with the wrench.
FIG. B
THE SAWDUST PORT (FIG. C)
The sawdust port has a 2-l/2“(O.D)/2-l/4’’(I.D) diameter open­
ing, suitable for attaching to a wet / dry vacuum hose, to help
keep the work area tree of sawdust.
1
.
2 .
3.
10 T
Remove the bolts (1) and washers (2) from the sawdust
port (3).
Open the lower wheel cover (4).
Attach the sawdust port to the edge of the wheel cover,
using the same hex. head bolts and washers.
Tighten the bolts and dose the cover.