A warning, Operation basic saw operations – Craftsman 137.224320 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Support bearing (FIG. S)
6. Loosen the bearing hex socket screw (7) with the hex
wrench.
7. Move the blade support bearing shaft (8) in or out until
the support bearing (9) is 1/64" behind the saw blade.
8. Tighten the bearing hex socket screw.
Pulley alignment (FIG.T)
The pulley alignment is adjusted properly at the factory and
should not need readjustment.
If adjustment is needed, or the belt needs replacing:
1. Place a.straight edge in the front groove of both pulleys,
behind the blade wheel.
2. Turn the hex socket screw (1) in the side of the motor
pulley (2) to loosen the pulley on the shaft.
3. Adjust the motor pulley in or out on the motor shaft (3)
to align the edges of the two pulieys.
4. When aligned, tighten the hex socket screw on the side
of the motor pulley.
OPERATION
BASIC SAW OPERATIONS
ON / OFF SWITCH (FIG. U)
The keyed switch is intended to prevent unauthorized
use of the band saw.
1. To turn the band saw ON insert the yellow key (1) into
the key slot (2) in the center of the switch.
2. Push the key firmly into the slot, then push switch
to the ON position to start the band saw.
3. To turn the band saw OFF push the switch to the
down position.
4. Remove the yellow switch key, when the saw has come
to a complete stop, by gently pulling it outward.
A WARNING
Remove the switch key whenever the saw is not in use.
Place it in a safe piace and out of reach of children.
FIG. U
GENERAL CUTTING
A WARNING
For your safety, read and understand all GENERAL and
SPECIFIC SAFETY INSTRUCTIONS on pages 3 - 5 before
using the band saw.
Operating band saws involves a certain amount of hazard.
Before attempting regular work, use scrap lumber to check
the settings, and to get the feel of operating the band saw.
Read instructions and plan your work before cutting a
workpiece,
Do not turn the power ON until after you have made all
adjustments, checked that the guard is in place, and turned
the wheel by hand to make sure all parts work properly.
Always keep the guide assembly close to your work, 1/8"
above the workpiece.
Do not force the workpiece, against the blade. Light contact
permits easier cutting and prevents unwanted friction and
heating of the blade.
Sharp saw blades need little pressure for cutting. Steadily
move the workpiece against the blade without forcing it.
1 6 i