Lower chute (see fig. 5), Upper chute (see figs. 6a & 6b), Level mower deck – Craftsman 917.24985 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5
LOWER CHUTE (See Fig. 5)
1. Raise and hold deflector shield in upright position.
2. Place slot in tower chute over tab on mower deck and
position lower chute over deck opening as shown.
3. Hook rear latch into flange hole on back of mower
deck.
4. Hook front latch into tab hole on front of mower deck.
A
CAUTION: Do not remove deflector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
DEFLECTOR
SHIELD
6
UPPER CHUTE (See Figs. 6A & 6B)
1. Lower mower deck to its lowest cutting position.
2. Assemble upper chute by inserting curved end into
hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger
indicator.
3. Push in and turn upperchute until it is in line with lower
chute.
4. Align the bosses on lower chute with alignment slots
on upper chute and slide together.
5. Secure with rubber latch by hooking hole in latch over
latch pin.
UPPER
CHUTE
FULL BAGGER
INDICATOR
HANDLE
COVER
FIG. 6A
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
LEVEL MOWER DECK
Be sure deck is properly leveled for best mower performance.
See your tractors owner's manual for instructions.