Save these instructions – Craftsman 136.748270 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dress properly. Keep hair, loose
clothing, fingers, and all parts of the
body away from openings and moving
parts. Be avi/are of the position of
the blower and the air inlets during
operation. Loose clothing, jewelry
and hair can be drawn into the Inlets
{refer to the following figure) and may
result in personal injury. Always wear
substantial footwear, long pants, and
eye protection.
Caution—Moving Parts—do not
operate the appliance without the air
inlet guard in place. Refer to Setup for
proper assembly instructions.
Do not use with damaged cord or
plug. If appliance is not working as it
should, has been dropped, damaged,
left outdoors, or dropped into water,
return it to a service dealer.
Do not pull or carry by cord, use cord as
a handle, close a door on cord, or puli
cord around sharp edges or corners.
Keep cord away from heated surfaces.
•
Do not unplug by pulling on cord, To
unplug, grasp the plug, not the cord,
•
Do not handle plug or appliance with
wet hands.
•
Do not put any object into openings. Do
not use with any opening blocked; keep
free of dust, lint, hair, and anything that
may reduce air flow,
•
Turn off all controls before unplugging.
“ Use extra care when cleaning on stairs,
•
Do not use to vacuum up flammable or
combustible liquids, such as gasoline,
or use in areas where they may be
present
•
This appliance Is provided with
double insulation. Use only identical
replacement parts. See instructions
for servicing of Double-Insulated
Appliances,
•
Do not vacuum anything that is
burning or smoking, such as cigarettes,
matches, or hot ashes,
•
Do not use without vac bag or proper
attachments in place.
•
This appliance is for household use
only
SAVE THESE
INSTRUCTIONS
Assembling the Blower
Install the blower tube and then the inlet cover onto the blower housing
Important: You must install the blower tube before installing the inlet cover because the
inlet cover hooks onto the blower tube . The blower will not run unless the inlet cover
is locked in place.
t Blower tube
2, inlet cover