Craftsman 136.748270 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A WARNING:
The motor impeller
rotates for a few seconds after you turn
off the blower and can cut or injure
fingers.
Do not remove the bottom inlet cover
when the motor is running or when the
unit is plugged into a power outlet
1 R e m o v e the inlet cover and the blower
lube from the blower housing.
Converting from Blower to Vacuum
Important: The vacuum will not run
unless the vacuum tube assembly is
locked in place.
4..
5, Adjust the strap as needed for
comfortable operation..
2 . Line up the arrows on the upper and
lower vacuum tubes and connect them
together, forming the vacuum tube
assembly
A
WARNING:
If you run the
vacuum without the lower tube, you
or bystanders could get caught in
the impeller blades and be injured.
Never run the blower without the
complete vacuum tube assembly
and do not separate the upper and
lower tubes once assembled.
Install the vacuum tube assembly onto
the blower housing.