Country Home Products DR - Manual (Page 16)

12 DR  COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Figure 4
Tire Pressure Check
There should be 40 psi in each tire.
Axle Brackets
Axle
Figure 3
Valve Stem
Flat
Washer
Bend
Figure 5
Cotter Pin
Safety Hitch Pin
Figure 6
9. Slide a Flat Wheel Washer over the Axle and
up against the Axle Bracket (Figure 3).
10. Lift the frame and with the valve stem facing
out, slide a wheel on the axle, install a second
flat wheel washer over the axle and slide it up
against the wheel hub (Figure 4).
11. Insert a cotter pin through the hole in the axle
and bend the top of the cotter pin over to
retain it in the assembly (Figure 5).
12. Repeat Steps 9 through 11 for the second
wheel.
13. Lift the tongue of the trailer and roll the
machine from the shipping pallet.
14. Holding the tongue level, remove the Safety
Hitch Pin from the nearest Support Leg
w/Caster in the front of the trailer frame and
allow the leg to drop. Replace the Safety Hitch
Pin in the hole provided to secure the leg in
the down position (Figure 6).
15. The remaining two (2) legs are installed upside
down for packaging. You need to remove them
and reinstall them from the bottom, making
sure that the holes in the legs are on the same
sides as the holes in the Engine Plate tubes.
Replace the Safety Hitch Pins in the holes
provided to secure the legs in the down
position (Figure 6).
16. Save your pallet and packaging material until
you are fully satisfied with your machine.
Wheel Washer here