To adjust seat, To assembly bagger – Craftsman 917.28035 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. Raise seat and tighten bolt securely.
6. Remove tape and discard.
7.
Lower seat into operating position and
sit on seat. Press brake pedal all the
way down. If operating position is not
comfortable, adjust seat.
TO ADJUST SEAT
Grasp adjustment handle and pull up, slide
seat to desired position and release adjust
ment handle.
NOTE:
You may now roll your tractor off
the skid. Follow the instructions below to
remove the tractor from the skid.
A WARNING:
Before starting, read, un
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKID (See
Operation section
for
location and
function of controls)
1.
Raise attachment lift lever to its highest
position.
2.
Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral position.
4. Roll tractor forward off skid.
5.
Remove banding holding the deflector
shield up against tractor.
Continue with the instructions that follow.
TO ASSEMBLY BAGGER
1. Unfold bag and stand right side up.
2.
Feed front bagger frame (1) up through
fabric loops at each side of bagger.
3.
Snap bottom offront baggerframe (1) into
snap feature at front of bagger bottom.
4.
Slidebaggerfabricloop
(2)
segmentsatthe
endsofbagontotopbaggerframetubing.
5.
Uninstall two (1 \4”-20 x 1.15”) hex bolts
(3) from the front of top frame.
6.
Reinstall the two (1\4”-20 x 1.15”) hex
bolts (3) through holes at top of the front
baggerframe and thread into nuts inside
the tubing of top bagger frame.
7.
Uninstall (1 /4”-20) lock nuts (4) at bottom
of front bagger frame.
8.
Unfold cross braces (5) and attach to
carriage bolts at bottom corners of front
bagger frame.
9.
Reinstall (1/4”-20) lock nuts (4) and
tighten until fully seated.
10. Remove clevis pin (6) and retainer spring
(7) from bagger handle (8).
11. Slide bagger handle (8) downthrough bag-
gercoverandframeupperweldmentholes.
12.
Reinstall clevis pin (6) through hole
at bottom of bagger handle and slide
retainer spring (7) into hole at the end
of the clevis pin until it locks into place