Craftsman 137.212370 User Manual
Craftsman Gardening equipment
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Operator’s Manual
10 In. SLIDING COMPOUND
MITER SAW WITH LASER TRAC®
Model No. 137.212370
CAUTION:
Before using this Miter Saw,
read this manual and follow
all its Safety Rules and
Operating instructions
Safety instructions
Installation
Operation
Maintenance
Parts List
Customer Help Line
Sears Parts &
For Technical Support
Repair Center
1-illl|.843«1S82
1-80Í-488-1222
Sears, Roebuck
and Co., Hoffman Estates,
IL
60179 USA
visit our Craftsman
Part No. 137212370001
Advertising
Table of contents
Document Outline
- 3. REMOVE ADJUSTING KEYS AND WRENCHES.
- 5. DO NOT USE IN DANGEROUS ENVIRONMENTS.
- 15. DISCONNECT TOOLS FROM POWER SOURCE
- 20, NEVER LEAVE THE TOOL RUNNING UNATTENDED. TURN THE POWER OFF. Do not
- ELECTRIGAL REQUiREMENTS
- ACCESSORIES AND ATTAGH!\/IENTS
- FORASSE
- SAW BLADE WRENCH (FIG. B-1)
- CUTTING HEAD (FIG. C)
- Locking
- INSTALLING THE DUST BAG (FIG. D)
- Fig.D
- Fig. E
- To avoid Injury:
- Fig.F
- MOUNTING THE MITER SAW (FIG. G, G-1)
- Fig. G
- Do not use a blade larger than 10 in. in diameter.
- Removing Blade (Fig. H, I and J)
- Fig. H
- Fig. J
- Installing Blade (Fig. H, I, J)
- THE LASER GUIDE (FIG. K)
- Fig.K
- To avoid injuty from an accidental start, make sure
- 90° (0°) Bevel adjustment (Fig. L)
- 90° Bevel Pointer Adjustment (Fig. M)
- 45“ Bevel Adjustment (Fig. N)
- Fig. O
- FIg.P
- MITER SCALE INDICATOR ADJUSTMENT (FIG. O)
- ADJUSTING FENCE SQUARENESS (FIG. P)
- ADJUSTING CUTTING DEPTH (FIG. Q)
- OPERATION
- KEEP YOUR WORK AREA CLEAN
- To avoid bums or other fire damage, never use the
- PLAN YOUR WORK
- INSPECT YOUR WORKPIECE
- DO NOT OVERREACH
- Never cut freehand:
- USE EXTRA CAUTION WITH LARGE OR ODD
- To avoid injury, follow all applicable safety
- BASIC SAW OPERATIONS
- TO TURN SAW ON (FIG. S)
- Finishing a cut:
- Fig. R
- To avoid injury, check and tighten the arbor bolt periodically.
- Fig.S
- To reduce the risk of injury, return carriage to the full rear position after each crosscut operation.
- BEFORE LEAVING THE SAW
- MITER CUT (FIG. U)
- Fig.V
- To avoid injury:
- To Slide Cut Wide Boards (Fig. Y)
- Fig.Y
- CUTTING BOWED MATERIAL (FIG. Z)
- Fig. BB
- Fig. CC
- Bevel/Miter Settings Fig. FF
- NOTE: The chart below references a compound cut for crown molding ONLY WHEN THE ANGLE
- MAINTENANCE
- TR0UBLESHCX3T1NG GUIDE