Craftsman 137.212370 - Manual (Page 2)

TABLE OF œhTTENTS
SECTION
Warranty..............................................
Product Specifications........................
Power Tool Safety..............................
Sliding Compound Miter Saw Safety
Electrical Requirements and Safety ...
Accessories and Attachments............
Tools Needed for Assembly...............
Carton Contents.................................
PAGE SECTION PAGE
2 Know Your Sliding Compound Miter Saw...... 8
2 Glossary of Terms................................................. 9
3 Assembly.............................................................. 10
4 Adjustments.......................................................... 14
4 Operation............................................................... 16
6 Maintenance.......................................................... 24
6 Troubleshooting Guide......................................... 25
7 Parts List............................................................... 26
WARRANTY
ONE-YEAR FULL WARRANTY ON CRAFTSMAN TOOL
If this Craftsman too! fails due to a defect in material or workmanship within one year from the date of purchase,
CALL 1-800-4-MY-HOME(B)TO ARRANGE FOR FREE REPAIR (or replacement if repair proves impossible).
If this too! is used for commercial or rental purposes, this warranty will apply for only ninety days from the date of
purchase. This warranty applies only while this tool is in the United States.
This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
A WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
« Lead from lead-based paints
•
Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well ventilated area and work with approved safety equipment such as
dust masks that are specially designed to filter out microscopic particles.
MOTOR MITER SAW
Power Source.................. .......120V AC, 60Hz, 15 Amp Cutting Capacity:
Arbor Shaft Size.............. ..... 5/8 in. Crosscut............................. ..... 3-5/8 in.
X
12 in
Speed ............................. ....... 4800 RPM (No load) Miter 45° R. & L.................. .....3-5/8 in. X 8 in.
Brake............................... .......Electric Bevel 45° L......................... ..... 1-5/8 in. X 12 in
Double Insulated..................... Yes 45° Miter and 45° Bevel...... ..... 1-5/8 in. X 8 in.
MITER SAW BLADE
Rotating Table: Diameter............................. ..... 10 in.
Miter Detent Stops........... ....... 0 °, 15°, 22 . 5 °. 31.6°, 45 ° R & L Arbor................................... .... 5/8 in.
Bevel Positive Stops........ .......OL 33.9°, 45° L
Extension Wings.............. .......Yes
A
WARNING
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /15 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your tool, it is critical that you read and understand these safety rules. Failure to follow these
rules could result In serious injury to you or damage to the tool.
............ :.......:.......:.......:.......:.......:.......:.......:.......:.........
2
........... ..