To start engine with a weak battery, Replacing battery – Craftsman 917.273481 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TO START ENGINE WITH A WEAK BAT­
TERY

^WARNING:

Lead-acid batteries gen­

erate explosive gases. Keep sparks, flame
and smoking materials away from bat­
teries. Always wear eye protection when
around batteries.

If your battery is too weak to start the

engine, it should be recharged. (See "BAT­
TERY" in the MAINTENANCE section of
this manual).

If “jumper cables” are used for emergency

starting, follow this procedure:

IMPORTANT:

Your tractor is equipped

with a 12 volt system. The other vehicle
must also be a 12 volt system. Do not use
your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1. Connect one end of the RED cable

to the POSITIVE (+) terminal of each

battery(A-B), taking care not to short
against tractor chassis.
Connect one end of the BLACK cable

to the NEGATIVE (-) terminal (C) of
fully charged battery.

Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery.

TO REMOVE CABLES, REVERSE
ORDER -

1. BLACK cable first from chassis and

then from the fully charged battery.

2. RED cable last from both batteries.

B

2

.

3.

fc> +

REPLACING BATTERY

^WARNING:

Do not short battery

terminals by allowing a wrench or any

other object to contact both terminals at

the same time. Before connecting battery,

remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected

first to prevent sparking from accidental

grounding.

1. Lift hood to raised position.

2. Remove terminal guard.
3. Disconnect BLACK battery cable

then RED battery cable and carefully

remove battery from tractor.

4. Install new battery with terminals in

same position as old battery.

5. Reinstall terminal guard.
6. First connect RED battery cable to

positive (+} battery terminal with hex
bolt and keps nut as shown. Tighten

securely.

7. Connect BLACK grounding cable to

negative (-) battery terminal with re­
maining hex bolt and keps nut. Tighten

securely

8. Close terminal access doors.
9. Close hood.

Keps Nut

------

Terminal

Access
Door

Terminal

Guard

Positive (Red)

Cable

Negative (Black)
Cable

Weak or Dead

Battery

Fully Charged
Battery

26

Advertising