Steps, Step 5, Step 4 – Craftsman 486.246212 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STEPS:

(SEE FIGURE 4)

• Attach left mounting bracket to hole shown in left side

of tractor frame using a hex bolt (C), flat washer (I)

and nylock nut (G). Align middle hole in bracket with

empty hole in tractor frame. Tighten nylock nut {G)

only enough to keep bracket in alignment until step 4.

Repeat for right mounting bracket.

STEP 5:

(SEE FIGURE 6)

• Replace the front screws and browning shield you

removed in Step 1 as shown.

STEP 4:

(SEE FIGURE 5J

•

Fasten bumper to mounting bracket using a hex bolt

(B), pivot spacer (E), a locking lever, a flat washer

(I) and a nylock nut (G) as shown. The pivot spacer

inserts into hole in bumper. Tighten both nuts on

mounting bracket at this time. Repeat for other side.

•

Assemble plastic grips (F) onto locking levers.

•

Lift up on bumper until pins in locking levers snap into

holes in mounting brackets.

IMPORTANT; You must lower bumper before raising tractor

hood. Pull out on locking levers and push bumper down as

far as it will go.

Advertising