Assembling to dual rod deck suspension tractors, Step 1, Step – Craftsman 486.246212 User Manual

Page 5: Step 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ASSEMBLING TO DUAL ROD DECK
SUSPENSION TRACTORS

[MPORTANT: These instructions are for tractors with

dual mower deck suspension brackets like the examples

shown in figure 2 on this page..

A

CAUTION! Muffler is hot! Allow engine to

cool down before proceeding with bumper

installation.

NOTE: Right hand (RH) and left hand (LH) are

determined from the operator's position while seated on

the tractor.

STEP 1:

•

Place cardboard on work surface.

•

Identify and lay out all parts and hardware. Not all

hardware will be used. Unused hardware may be

discarded after assembly.

•

Remove tractor hood. (Refer to tractor manual.) Place

hood on cardboard or on a mat to protect paint.

STEP

2: (SEE FIGURE 1)

• If you have an (LT) Lawn Tractor with a heat shield

like the one shown, remove the heat shield.

IMPORTANT: Be sure to re-attach the heat shield after

bumper is installed.

STEP 3:

(SEE FIGURE 2 )

IMPORTANT: Do not remove any bolts from the tractor

frame while the mower deck is raised. Misalignment of

holes in frame could result.

•

Lower mower deck to rest on ground.

•

Remove bolts from mounting holes on both sides of

tractor frame. Use a mounting bracket to help identify

holes.

FIGURE 2

Advertising