Craftsman 911041 - Manual (Page 5)

OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED, After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing,
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “Charging
a Cool Battery Pack” for normal recharging of batteries.
If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Sears Repair Center for electrical
check.
USE 11041 BATTERY CHARGER ONLY WITH
BATTERY PACKS LISTED BELOW.
TYPE 1 BATTERY PACK MODEL NUMBERS
{require 1 hour to charge)
1310715,1322521,1322522,1323408,1323409,1323501,
1323502,1323505,1323506,1323513,1323514,1323516,
1323517, 1323903, 1323905, 1325101, 130235029,
130238003,
130238005, 130251008, 130279001,
130279002, 130279003, 130279004, 130279005,
130287001
CHARGER CAN ALSO BE USED FOR PRODUCTS
WITH THE FOLLOWING ITEM NUMBERS
10153,11044,11045,11068,11375,11403,11426,11427,
11428,11430,11442,11448,11453,11462,11485,11512,
11516,11538,11539,11540,11541,11542,11543,11544,
11545, 11546, 11574, 11575