Cleaning, Service and adjustments, Tractor – Craftsman DYT 4000 917.273642 User Manual

Page 22: To remove mower, To install mower

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING

• Clean engine, battery, seat, finish, etc.

of all foreign matter.

• Keep finished surfaces and wheels free

of all gasoline, oil, etc.

• Protect painted surfaces with automotive

type wax.

We do not recommend using a garden

hose or pressure washer to clean your

tractor unless the engine and transmis­
sion are covered to keep water out. Water

in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.

SERVICE AND ADJUSTMENTS

A

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER­
VICE OR ADJUSTMENTS:

1. Depress clutch/brake pedal fully and set parking brake.

2. Place motion control lever in neutral (N) position.

3. Place attachment clutch in “DISENGAGED” position.

4. Turn ignition key to “STOP” and remove key.

5. Make sure the blades and all moving parts have completely stopped.

6. Disconnect spark plug wire from spark plug and place wire where it cannot

come in contact with plug.

TRACTOR

TO REMOVE MOWER

Mower will be easier to remove from the
right side of tractor.

1. Place attachment clutch switch in “DIS­

ENGAGED” position.

2. Move attachment lift lever forward to

lower mower to its lowest position.

3. Roll belt off electric clutch pulley.

4. Disconnect anti-sway bar from chassis

bracket by removing retainer spring.

5. Disconnect suspension arms from rear

deck brackets by removing retainer
springs.

Suspension

Arms f

6. Disconnect front links from deck by

removing retainer springs.

7. Raise lift lever to raise suspension

arms. Slide mower out from under trac­
tor.

IMPORTANT: If an attachment other than

the mower deck is to be mounted on the
tractor, remove the front links.
TO INSTALL MOWER

1. Raise attachment lift lever to its highest

position.

2. Slide mower under tractor with deflec­

tor shield to right side of tractor.

3. Lower lift lever to its lowest position.

4. Connect front links to mower deck and

secure with retainer springs.

Electric

Clutch

Pulley

Retainer
Spring

Retainer Springs

(Both Sides)

Anti-Sway

Bar

Deflector Shield

Retainer Spring

22

Advertising
This manual is related to the following products: