Craftsman 917.2720601 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
 
MOWING TIPS
• Mower should be properly leveled for 
best mowing performance. See “TO 
LEVEL MOWER HOUSING" in the 
Service and Adjustments section of 
this manual.
• The left hand side of mower should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has already been 
cut. Have the cut area to the right of 
the tractor. This will result in a more 
even distribution of clippings and more 
uniform cutting.
• When mowing large areas, start by
turning to the right so that clippings will
discharge away from shrubs, fences,
driveways, etc. After one or two
rounds, mow in the opposite direction 
making left hand turns until finished.
r
r
N
"
L_____ _______ )
L
^ i
j
(
V.
If grass is extremely tall, it should be
mowed twice to reduce load and
possible fire hazard from dried clip
pings. Make first cut relatively high; the 
second to the desired height.
Do not mow grass when it is wet. Wet 
grass will plug mower and leave
undesirable clumps. Allow grass to dry 
before mowing.
Always operate engine at full throttle 
when mowing to assure better mowing
performance and proper discharge of 
material. Regulate ground speed by 
selecting a low enough gear to give the 
mower cutting performance as well as 
the quality of cut desired.
When operating attachments, select a 
ground speed that will suit the terrain 
and give best performance of the 
attachment being used.
MULCHING MOWING TIPS 
IMPORTANT: For best performance, 
keep mower housing free of built-up 
grass and trash. Clean after each use.
• The special mulching blade wilt recut
the grass clippings many times and
reduce them in size so that as they fall
onto the lawn they will disperse into the 
grass and not be noticed. Also, the 
mulched grass will biodegrade quickly
to provide nutrients for the lawn.
Always mulch with your highest engine 
(blade) speed as this will provide the 
best recutting action of the blades.
• Avoid cutting your lawn when it is wet.
Wet grass tends to form clumps and 
interferes with the mulching action.
The best time to mow your lawn is the
early afternoon. At this time the grass 
has dried and the newly cut area will 
not be exposed to the direct sun.
• For best results, adjust the mower
cutting height so that the mower cuts off 
only the top one-third of the grass 
blades. For extremely heavy grass, 
reduce your width of cut on each pass 
and mow slowly.
Max 1/3
Certain types of grass and grass 
conditions may require that an area be 
mulched a second time to completely
hide the clippings. When doing a 
second cut, mow across or perpendicu
lar to the first cut path.
Change your cutting pattern from week 
to week. Mow north to south one week 
then change to east to west the next 
week. This will help prevent matting 
and graining of the lawn.
17