Craftsman 320.28190 User Manual
Ciiftsmi
Advertising
Table of contents
Document Outline
- ONE YEAR FULL WARRANTY ON CRAFTSMAN TOOL
- SAVE THESE INSTRUCTIONS!
- READ ALL INSTRUCTIONS!
- WARNING: BE SURE to read and understand all instructions in this manual before using this router. Failure to follow all instructions may result electric
- WORK AREA SAFETY
- PERSONAL SAFETY
- ELECTRICAL SAFETY
- EXTENSION CORDS
- SAFETY
- SYMBOLS FOR YOUR TOOL
- SERVICE SAFETY
- INSPECT the tool cords periodically and if damaged have them repaired at your nearest Sears Service Center. BE AWARE of the cord location.
- 1. 12.5 Amp, 2-1/4 Peak HP, Variable Speed Router Motor runs at 12,000 to 25,000 RPM (no-load speed).
- 9. Base features Large Base Opening and Large Chip Shield, combined with 3 LED Work lights on Router Motor to provide high visibility of bit and work piece.
- INSTALLING THE CUTTING BIT
- CAUTION: To prevent damage to tool, do not tighten collet/nut without a cutting bit installed.
- COLLET/NUT CARE
- CUTTING BITS
- INSTALLING ROUTER MOTOR IN BASE
- INSTALLING ROUTER MOTOR IN BASE (Fig. 5)
- Deep Cuts
- TOGGLE “ON/OFF” SWITCH (Fig. 7)
- SOFT START FEATURE :
- “LIVE TOOL INDICATOR” LIGHT (Fig. 9)
- HEAVY-DUTY EDGE GUIDE (Fig. 10)
- DETACHABLE POWER CORD (Fig 11)
- Electronic Variable Speed Control
- ELECTRONIC FEEDBACK CIRCUITRY
- PLACING THE ROUTER ONTO THE WORKPIECE AND STARTING THE CUT
- EDGE ROUTING OR INTERNAL ROUTING
- DIRECTION OF FEED - EXTERNAL CUTS (Fig. 16)
- CHIP SHIELD DEFLECTOR (Fig
- WARNING: The chip
- DUST COLLECTION WITH DUST EXTRACTION AD/^PTER (Fig. 2D)
- To adjust Depth with the Depth-Adjustment Wrencfi (Fig. 21}
- GENERAL
- ROUTINE MAINTENANCE
- REPLACEMENT OF CARBON BRUSHES (Fig. 22)
- LUBRICATION
- WARNING: The use of attachments or accessories that are not recommended for this tool might be dangerous and could result in serious injury.
- BER 3S>28iro^^*^ ^ R^ODEL NUM-