Craftsman 536.886141 - Manual (Page 4)

17. Disengage power to the auger/impeller
■ ■ * ■ sported c I or when snow thrower is transporte
not in use.
18. Use only attachments and accessories
approved by the manufacturer of the
snow thrower (such as tire chains,
electric start kits, etc.).
19. Never operate the snow thrower
without good visibility or light. Always
be sure of your footing, and keep a
firm hold on the handles. Walk; never
run.
MAINTENANCE AND STORAGE
1. Check shear bolts and other bolts
frequently for proper tightness to be
sure the snow thrower is in safe
working condition.
2. Never store the snow thrower with fuel
in the fuel tank inside a building where
ignition sources are present such as
hot water and space heaters, clothes
dryers, and the like. Allow the engine to
coo! before storing in any enclosure.
3. Always refer to operator’s manual
instructions for important details if the
snow thrower is to be stored for an
ejctended period.
Contents of Parts Bag (actual size)
1 - Owner's Manual (not shown)
1 - Packet of Fuel Stabilizer (not shown)
1 - Warranty Card (not shown)
2 - Parts Bags (not shown)
"Non-Assembly Parts, found
in tool box located on belt cover.
4. Maintain or replace safety and instruc
tion labels, as necessary.
5. Run the snow thrower a few minutes
after throwing snow to prevent freeze-
up of the auger/impeller.
/K WARNING: This snow thrower is for
use on sidewalks, driveways and other
ground level surfaces.
Caution should be exercised while using on
steep sloping surfaces. DO NOT USE
SNOW THROWER ON SURFACES
ABOVE GROUND LEVEL such as roofs of
residences, garages, porches or other such
structures or buildings.
AVOID INJURY FROM
ROTATING AUGER-
;■ KEEP HANDS, FEET,
AND CLOTHING AWAY!
STOP THE ENGINE
BEFORE UNCLOGGING
DISCHARGE CHUTE!
1 -Washer, Hvsptik 1- Nut, 1/2-13 Hexjam
*2 - Spare Spacers
*2 - Shear Pins - Starter Motor Cord 10Ft.
3 -Hex Nylon Nuts, 5/16-18 4 - Flatwashers 11/32 In.
1- Shifter Knob
1
1- Nut, 5/16-18 Reghex