Canon EOS 1000N User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1) Make sure the command dial is not at L.
2) Open the back cover by sliding the latch
down.
3) Insert the film as shown with the flat end
of the cartridge on top.
4) Carefully pull the film tip across until it
reaches the orange mark.
5) Make sure the film lies flat and close the
back cover.
Film winding starts and the frame counter
counts up. When the film is completely
wound, the shutter is released once;
however, no picture is taken. The film car
tridge symbol and the number of available
frames are displayed in the LCD panel.
• If the film cartridge symbol blinks, the
film has not been loaded properly and
the shutter will not release. Reload the
film.
• Film becomes soft and tears easily in
high humidity. Keep it stored in its
canister until loading.
13