LG WT1201CW - Manual (Page 25)

USING YOUR WASHING MACHINE 25
Setting RINSE + SPIN, RINSE + SPIN
Select this option to rinse and spin a load separately from a
regular cycle. This can be helpful in preventing fresh stains
from setting in fabrics. You can change spin speed by
pressing SPIN SPEED repeatedly until the desired speed is
selected.
1 Press the POWER button to turn on the washer.
2 Press the (^) button until the RINSE+SPIN indicator light
is lit. (The cycle light will turn off.)
3 Press the ( S i s button to start the cycle. The washer will
start automatically.
Setting SPIN ONLY, SPIN ONLY
This button activates the SPIN ONLY cycle to drain and spin.
1 Press the POWER button to turn on the washer.
2 Press the (^) button repeatedly until the SPIN ONLY
indicator light is lit.
3 Press the ( ^ button to start the cycle. The washer will
start automatically.
Setting soak, SOAK
Helps remove stains by adding a soak time before the beginning
of the cycle. The cycle time will increase by 30 minutes. The
agitation of the washer will be weaker during a Soak cycle.
O NOTE-----------------------------------------
You cannot select the Soak option during the Tub Clean
cycle.
Saving energy, COLDWASH"^
For maximum efficiency, wash only small loads, (less than 8
lbs.)
rO NOTE-------------------------------------------
Press and hold the COLDWASH™ button for three
seconds to activate or deactivate SIGNAL. SIGNAL is
the melody and button tones.
1 Press , and press repeatedly until the
desired cycle is selected.
2 Press (^) The washer will automatically adjust the cycle
settings.
3 Set any other desired options.
4 Press
rO NOTE------------------------------------------
When you select the COLDWASH™ option, wash time
will be increased up to 10 minutes.
For high wash dfficiency, it is recommended to use
less than 8 pounds.
Adding extra rinse cycle, EXTRA RINSE
You can add an extra rinse cycle to the default rinse cycle.
1 Press ^ and press ^*) repeatedly until the
desired cycle is selected.
2 Press (^.
3 Press the desired option to use the other options.
Skip to step 4 to use the default setting without
changing the options.
4 Press 0*)
i