CLIFFORD 420.4X - Manual (Page 27)

24 © 2011 Directed Electronics. All rights reserved.
Remote Start Faults
For user safety, the system must be properly configured or remote
start will not activate. A Remote Start Fault may be caused by any of
several configuration issues. Refer to the table below for the command
type and parking light flashes that will identify the configuration issue
and solution.
Flashes * Possible Fault Solution
5 Brake on Release foot brake
6 Hood open Close hood
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
Enable MTS mode
Check all Solutions
8 Toggle Switch off Turn switch on
* Refers to the number of parking light flashes.