Chief Manufacturing JWDSK - Manual (Page 7)

Installation Instructions JWDSK Series
7
Figure 7
2. Align two screws in display back with upper teardrop
mounting holes in mounting plate.
3. Place two screws in display back into upper teardrop
mounting holes in display mounting plate and lower display
until screws are seated in lower area of teardrop mounting
holes. (See Figure 8)
4. Install two screws through display mounting plate and into
lower mounting holes in display back. (See Figure 8)
5. Tighten all hardware.
Figure 8
6. Route cables and wires to display.
CABLE MANAGEMENT
1. Attach all cables to display.
CAUTION: Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of cover (B) or screws (C).
2. Carefully insert cables in cavity located in lower portion of
mount arm (See Figure 9).
3. Using Phillips screwdriver, install cover (B) with two screws
(C). (See Figure 9)
Figure 9
ADJUSTMENTS
Swing Arm
PIVOT / SWING
1. Using 3/16" hex key (G), slightly loosen or tighten the
adjustment screw(s) as necessary. (See Figure 10)
Figure 10
x2
1
x 2
4
3
2
(C) x 4
Cable Path
(typical)
(B) x 2
Adjustment Screws