Alumax 650D - Manual (Page 5)

Page 5 G03920296
8-13-09
6
4
Replace one wall jamb [B] and attach to the wall
with a #8 x 1 1/2” truss head screw [D] through the
middle hole. Place a #8 x 1 1/2” truss head screw [D]
through one of the top jamb bumpers [E] and attach
through the top hole.
For proper orientation of the bottom jamb bumper
[F]
refer to the detail, and note that the one on the wall jamb
closest to the shower head, the lip is turned to the interior
of the enclosure, and that the other one is turned to the
exterior. Attach the bottom jamb bumper
[F] with a #8
x 1 1/2” truss head screw [D].
NOTE: Do not over tighten the screws.
NOTE: Obscure glass doors should be installed
with the rough surface of the glass to the exterior of the
unit. Deco or etched glass doors should be installed
with the patterned surface to the interior.
On doors with obscure or etched glass there is an interior
and exterior glazed door panel
[H] as determined by the
position of the top bearing fin. Door panels with clear
glass are interchangeable.
Attach the 4 nylon roller bearings
[I] to the door panels as
shown, using #8-32 x 3/8 hex head screws [J] centered
in the outside slots in the top bearing fins.
5
This Bath enclosure is equipped with safety tee-
lock wall jambs. When properly installed, the header
is permanently locked to the wall jambs and cannot be
accidentally dislodged.
Measure the wall-to-wall opening at the top of the wall
jambs
[B] and cut the header [G] 1/16” short of this
dimension. Check the header [G] for fit.
Slide the safety tee-lock of the un-mounted wall jamb [B]
into the end of the header [G]. The header is reversible
so that either face may be turned to the exterior of the
unit. Holding the header
[G] at an angle, engage the
other end into the safety tee-lock of the mounted wall
jamb. Pivot the header
[G] into place, slide the loose
wall jamb [B] to the wall and press into position over
the tub track [A]. Mount the wall jamb [B] to the wall
as described in step #4, taking note of the orientation
of the bottom jamb bumper
[F].