Attwood 7563 Two-Position Pull Switch - Manual

3
®
Attwood marine hardware, navigational lighting, bilge pumps, and other
marine accessories are specified more than any other brand by America’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
SAVE THESE INSTRUCTIONS
Form Number 69308 Rev. A 03-10
Two-Position Pull Switch
7563
Installation Instructions
REQUIRED FOR INSTALLATION
• Drill with
³⁄₈ " (10mm) dia. bit.
• Slotted screwdriver.
• Pliers.
APPLICATION
• Install switch in dashboards or panels up to 1" (25mm) thick.
• Switch requires 1
¹⁄₄ " (31mm) depth behind panel.
• Rated load is 20 amps.
MOUNTING INSTRUCTIONS
1. Bring power source wire and switched wire to panel. Attach wires
to terminal screws.
2. Remove chrome handle and nut from shaft.
3. In desired location, drill ³⁄₈ " (10mm) dia. hole through panel. From
inside panel, insert shaft through hole.
4. Tighten chrome nut and handle onto end of shaft. From inside,
tighten brass nut and washer against panel.
Figure 1
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
Chrome
Handle
Chrome
Nut
3/8"
(10mm) Dia.
Brass
Nut
Brass
Washer
Panel:
1" (25mm) Max
Terminal Screw
•
• •
•
•
•
•