AVer SF2012H-B user manual User Manual
Page 52
49
Event > Arrangement > Preference
Record File:
File Format: IP camera allows 3 different types of recording file to change its record size. When
motion/alarm is triggered, there are 3 different types of record mode.
−
AVI File (With Record File Setting )
−
JPEG Files (With Record File Setting), only with M-JPEG compression format.
−
Single JPEG (Single File with Interval Setting)(JPEG photo).
Pre Alarm and Post Alarm: Setups for video start and end time when motion detected, I/O, or
other devices got triggered.
[Note] Pre/Post Alarm record time is base on record time setting and IP camera built-in Ram
memory. Limited by IP camera built-in Ram Memory, When information is too much or video
quality set too high, it will cause recording frame drop or decrease on post alarm recording time.
Network Connected: When the network is down, it will save the video to local SD/SDHC card.
[Note]This function is only enabled in wire connection.
Network IP check: When the connection is down, it records the video to SD/SDHC card. Make
sure the video recording is continuous. To use this function, key in the IP address of the PC which
has recording software installed. Enable the function of “Save to SD card”, then click “Apply”.
[Note] The interval of two video files on SD/SDHC card is fixed with 30 seconds.