B&M 30262 SHIFT IMPROVER KIT - Manual (Page 6)

6
TOOLS REQUIRED FOR TURBO HYDRO 350
SHIFT IMPROVER KIT INSTALLATION
underneath so exercise care. Remove the accumulator
cover, O-ring and accumulator spring. Discard the O-ring
and spring. Install new O-ring supplied with the kit in
position on the accumulator cover. Lubricate the O-ring
with automatic transmission fluid and install cover and O-
ring into case. Install snap ring making sure it is fully
seated in its groove.
STEP 17. Check shifter adjustment. Place selector lever
in each gear position making sure detents in transmission
correspond exactly with selector lever detents.
Adjustments can be made by loosening pinch bolt on
rod or cable.
STEP 18. Detent cable: Depress accelerator pedal fully
and check that throttle is opening fully. Adjust if necessary. Adjust detent cable so that full throttle coincides
with maximum cable position.
STEP 19. Lower vehicle. Keep the rear wheels off the
ground if possible. Add five quarts of B&M Trick Shift or
Type F Automatic Transmission Fluid. Trick Shift is
superior in lubrication, heat capacity and friction material
performance, if Trick Shift is not available we suggest
using Type F fluid. Place transmission in neutral, start
engine and fill to the “Add” mark. Place selector lever in
all gear positions. If the wheels are off the ground, allow
the transmission to shift through all gears. Check fluid
level and make sure it is between “Add” and “Full”.
STEP 20. Lower vehicle and drive for 1-2 miles to warm
fluid. Check level again. Do not overfill! This can use
foaming and overheating.
1 Speed Handle or Ratchet
1 Vise.
1 1/2" Socket
1 File
1 Large Blade Screwdriver
1 Awl
1 Small Blade Screwdriver
I 1/4" Drill Motor
1 Torque Wrench 0 to 50 ft.-lbs.
5 Qts. B&M Trick Shift or Type F ATF
1 Drain pan
1 Gal. Solvent