B&M 45043 PRECISION SPORT SHIFTER - O4 + GTO - Manual (Page 6)

Torque 1/4-20 bolts to 8-10 ft-lbs.
Caution do not overtorque bolts!!
Torque M8 thin nuts to 8-10 ft-lbs.
Torque M8 nuts to 15 ft-lbs.
Leave approx. 0.9" of M8 set
screw thread above GTO Trans
after locking down GTO Trans.
A S S E M B L Y
STEP 14. Install B&M shifter using (2) 1/4-20 bolts, (2) lock
washers, (2) M8 nuts, (2) M8 thin nuts and (2) M8
washers.
(SEE DIAGRAM BELOW FOR DETAILS)
TOOLS: Screwdriver (flat), Hex Wrench (6mm), thread
adhesive, and wrench (13mm)
NOTE: FAILURE TO USE THREAD ADHESIVE COULD
RESULT IN SHIFTER MALFUNCTION.
STEP 15. Reinstall rubber boot.
NOTE: On some earlier models a black boot was used
which may need some trimming of the opening to
allow for full gear engagement of 1, 3 & 5th gear.
Or you can replace the black boot with the newer
white boot, GM P/N: 92169196.
STEP 16. Install top stick L using (2) 5/16-18 bolts and
thread adhesive.
TOOL: 3/16 Hex and adhesive.
Torque bolts to 26 ft./lbs. (35 N/m)
NOTE: FAILURE TO USE THREAD ADHESIVE COULD
RESULT IN SHIFTER MALFUNCTION.
L
.9"
M8 NUT
M8 LOCKWASHER
M8 FLAT WASHER
B&M BASE
M8 THIN NUT
GTO TRANS
GTO TRANS GASKET