B&M 77106 STARTEK STARTER, GM, LS1 THROUGH LS7, NOT GTO - Manual

Instructions
B&M StarTek Starter
(see www.bmracing.com for the latest vehicle fitment applications and model years)
Part Number 77106 – GM LS1 – LS7 Engines (Not GTO)
© 2013 by B&M Racing and Performance Products
1 9500889-01
Proper installation of your StarTek
Starter is essential for trouble free
operation. Correct alignment and
spacing is required. Please read all
instructions before installing your
new high performance starter.
INTRODUCTION
This starter can be installed in about
an hour by carefully following the
instructions. It is suggested that the
vehicle be allowed to cool off for a
few hours to avoid burns from hot
parts, especially any exhaust parts
which might be near the starter. The
vehicle should be off the ground for
ease of installation - jack stands,
wheel ramps or a hoist will work
fine. MAKE SURE VEHICLE IS
FIRMLY SUPPORTED - DO NOT
WORK UNDER A VEHICLE IF IT IS
SUPPORTED BY ONLY A JACK!
Try to raise the vehicle 1-2 feet so
you will have plenty of room to work.
INSTALLATION
STEP 1. Disconnect battery cables,
removing the negative cable first.
STEP 2. Remove the old starter,
and make sure the mounting flange
is clean and burr free.
STEP 3. Install the new starter with
the supplied hardware. Leave all
shims out at this time. Torque
mounting bolts to 32 ft-lbs.
STEP 4. With the starter now in
position, make sure the solenoid
housing and starter body have maximum clearance from heat
sources and other components. The
starter can be clocked in different
locations on the mounting block to
obtain the best position. To re-clock,
Figure 1: Starter Clocking Positions