B&M 80685 MEGASHIFTER, RHD - Manual (Page 3)

3
Figure 4
Remove this blocker
pin and the two e-
clips for GM four
speed transmissions
Figure 3
Indicator
cable
E-Clip
Bracket
Sheet metal
screw (2)
equipped with a cast aluminum oil pan,
these spacers should be omitted. With
a TH-400 with a cast aluminum oil pan,
the cable bracket may have to be
modified.) Install the two 5/16-18 x
1.00" bolts (Metric transmissions use
the two 8mm x 25mm bolts) supplied
and tighten 12-13 lb.ft. Do not over-
tighten as this can damage the pan
gasket.
STEP 12. Route the shifter cable ac-
cording to Figure 4. Avoid kinks and
sharp bends and route the cable away from hot engine or exhaust parts.
Remove the two rubber boots, one
large nut, and a large lock washer from
the threaded end of the shifter cable.
Slide the end of the cable into the cable
bracket. Install the large nut and the
lockwasher loosely over the end of the
cable. Install the two rubber boots onto
the end of the cable. Install the swivel
on the threaded end of the cable and
position it in the center of the threaded
portion.
STEP 13. Move the transmission se-
lector lever by hand to the full rear
position (Low). Operate the shifter le-
ver to the Low gear position (ratcheted
all the way back). Adjust the large nuts
on the cable so that the swivel will slide
into the front hole on the selector lever.
Tighten the large nuts completely. Be
sure that the swivel will slide freely in
and out of the hole in the selector lever.
Note: The shifter will not operate
correctly unless the front hole in
the shift lever is used.
Leave the swivel out of the hole and
7.50"
1.00"
11.75"
TRIM AS
REQUIRED
Figure 2
Washer (2)