B&M 80798 STREET BANDIT SHIFTER - Manual

9500754-01 Printed in the U.S.A.
The B&M Street Bandit Shifter - Hard
Core is a gate pattern type shifter
mechanism. It is available as a rear exit
cable model only and it is designed for
most three and four speed
transmissions with standard pattern
valve bodies. The B&M Street Bandit
Shifter - Hard Core features a neutral
safety switch and a reverse light switch
as required for all street vehicles.
Please read the instructions and review
the illustrations thoroughly before
beginning the installation.
IMPORTANT: You must first install
the shifter cable onto the shifter before
positioning the shifter in your vehicle.
This is to insure that you allow for
proper clearance at rear of shifter be-
fore you permanently mount the shifter
body into the vehicle. Mounting the
shifter first without the cable attached
can cause possible interference from
interior components. Poor cable rout-
ing and cable binding will result in poor
shifter operation or cable damage.
INSTALLING THE SHIFTER CABLE
STEP 1. Pull the shifter stick all the
way back to the Low gear position.
Remove the five countersunk screws
from the shifter cover and remove the
cover. Locate the cable attachment pin
at rear of shifter stick. The pin is visible
just under the black shift pattern gate
plate. Do not remove black gate plate
(See Photo #1).
IMPORTANT: The three speed gate
plate is assembled on the shifter mecha-
nism by the B&M assembly techni-
cians. If your transmission is a GM four
speed, now is a good time to install the
four speed gate plate. Please refer to
page 8 for gate plate change instruc-
tions. STEP 2. Fully extend the stamped loop
end of the shifter cable and insert it
through the largest access hole in the
rear of the shifter body. Slip the stamped
loop cable end over the cable attach-
ment pin at the rear of the shifter stick
and attach the supplied e-clip to the
pin. Check to make sure you have the
e-clip firmly & accurately in the locat-
ing groove in the pin (See Photo #2).
STEP 3. Push the cable anchor tab
I
nstallation Instructions
Street Bandit Shifter - Hard Core
Part Number 80798
(see www.bmracing.com for the latest technical product information)
©2006, 2001 by B&M Racing and Performance Products
Photo #1
shifter cover
shift pattern
gate plate
cable attachment pin
(stick all the way back)