B&M 81020 HAMMER CONVERSION KIT - Manual (Page 3)

and backup light switches. Reroute the
wires to the shifter and lengthen if
necessary. Strip 1/4" insulation off
wires and install supplied slip-on ter-
minals. Crimp terminals onto wires
using a crimping tool or pliers. Con-
nect the Neutral safety wires to the
LOWER switch and the Reverse light
wires to the UPPER switch, See fig-
ure 2. Tape terminal connections to
prevent shorts. Reconnect battery
ground cable, disconnect coil wire and
set the parking brake. Check switch
operation by attempting to start motor
in each shifter position. The starter
must crank only when shifter is in
the Park or Neutral position. Check
Backup light operation when the shifter
is shifted to the Reverse position. Ad-
just switches if required. Reconnect
coil wire.
After the switches are correctly
wired, continue with replacing the con-
sole and installing the top plate as cov-
ered in the shifter instructions.
Figure 4
Figure 3
Replace cable pin
Cable bracket
spacer
Ford lever
C-6 cable bracket
C-4 / C-5 cable bracket
Figure 5