Salter Brecknell B120 - Manual (Page 11)

9
8. Remove the items from the scale and repeat steps 7 and 8 to weigh the
next batch of items.
Counting with upper and lower limits can be done while using a tare. After you
have set the piece weight (step 2 ), place the item to be tared on the scale,
press the Tare key and continue with counting as described in step 3 .
Note: Upper and lower limits will remain in memory until you reset the limits to
0, by repeating steps
3
- 6 .
Accumulating Counts
The scale can accumulate the counts from different weighments into a total
value stored in memory. Follow these steps to perform accumulations.
1. Follow the different counting methods described in
Scale Operation
on
page 5 to count items placed on the scale.
2. When the count is displayed, press the Accu+ key to accumulate the
count to memory…
The count is added into memory, and temporarily, Add is displayed in
the WEIGHT window, the number of accumulations is displayed in
the PIECE WEIGHT window and the accumulated count is shown in
the COUNT window. The display automatically returns to the normal
counting mode.
3. Remove the items, allow the scale to return to zero weight and count,
and repeat the process of putting items on the scale and pressing the
Accu+ key to accumulate the counts…
The total of accumulated counts is shown in the COUNT window.
4. To clear the accumulator, press Accu+ key, then the Clear key while the
accumulated data is displayed…
Memory is cleared of the accumulated data and the scale returns to
normal counting mode.
Note: To view the accumulator data, remove all weight from the scale and
press Accu+. The data is temporarily displayed before returning to count
mode.