Salter Brecknell B120 - Manual (Page 2)

B120_u_AWT35-500140.book
Warnings
Safe Installation
Pluggable equipment must be installed near an easily accessible socket
outlet.
The socket outlet must provide a protective earth contact and the electrical
supply to the outlet must provide over current protection of an appropriate
rating.
Permanently protected equipment must have a readily accessible disconnect
device incorporated in the fixed wiring.
The fixed wiring must provide a protective earth connection and the supply
must incorporate over current protection of an appropriate rating.
USA
If the scale is connected to a 240V supply, the receptacle must be protected
by a 15 amp circuit breaker.
This equipment is intended for use in dry conditions.
For your protection, all mains (110V or 240V) equipment used out of
doors or in wet or damp conditions should have adequate
environmental protection.
We recommend:
• a correctly fused source protected by an approved outlet/connector that
complies with local legislation (BS7071 or BS7288 in the UK).
• or an RCD protected supply to BS EN 61008 or BS EN 61009 (UK & Europe)
IF IN DOUBT, SEEK ADVICE FROM A QUALIFIED ELECTRICIAN.
A copy of the original signed declaration for this instrument is available from
the UK address at the end of this book.
Declaration of Conformity
Manufacturer Salter Brecknell
Type B120
Corresponds to the requirements of the following EC directives:-
Electro Magnetic Compatibility
Low Voltage Directive:
EMC 89/336/EEC
LVD 73/23/EEC
The application harmonised
standards are: EN60950-1: 2002, EN61000-6-1: 2001
EN61000-6-3: 2001