Salter Brecknell B120 - Manual (Page 16)

14
9.0 Displayed Messages
¯ ¯ ¯ ¯ ¯ ¯
Scale overloaded
- - - - - - Too many accumulations or accumulated counts too high
_ _ _ _ _ _
Weight signal is too small
0¯ ¯ ¯ ¯ ¯
The zero point is too high
0_ _ _ _ _
The zero point is too low
EEP.Er0
The EEPROM can’t be accessed
EEP.Er1
The parameters in EEPROM are not same with backup data
EEP.Er2
The setting parameter(s) is not in normal range, or the parameter
has not been set
CAL.Err
There is an error in calibration: maybe the loaded weight is too
small or the input weight is not correct.
Ad¯ ¯ ¯ ¯
Input signal of ADC is over max. range
Ad _ _ _ _
Input signal of ADC is below min. range;
CAP
Displaying data relating to capacity
UoL
Displaying data relating to voltage
Add
The accumulated data
PC.t:
Data about piece weight
SPL.PCS
Data about sample pieces
uP.PCS
Data about upper limit pieces
Lo.PCS
Data about lower limit pieces
unLoAd
Unload weight on the platter
InP.Ld
Input loaded weight’s number
CAL.oN
Calibration enable switch is ON
CAL.oFF
Calibration enable switch is OFF