Salter Brecknell B120 - Manual (Page 9)

7
4. Press the Enter key to accept the keyed in number. (If you make an
error in keying in the number, press the Clear key to clear the count in
the COUNT window and re-key the correct number.)…
The scale calculates the weight of each piece (the piece weight) and
displays the count in the COUNT window.
5. Place the items to be counted on the scale…
The total weight, piece weight and count of the items will be shown in
the three display windows respectively.
6. Remove the items from the scale and repeat steps 5 and 6 to count
items of the same piece weight.
7. Repeat steps 1-6 to count items of a different piece weight.
Note: Piece weight is displayed in grams/decimal grams or LB/decimal
pounds.
Note: The original piece weight will be held in memory until a new piece
weight has been determined. Turn the scale off, then on to return to normal
weighing mode.
Counting by Entering a Known Piece Weight
You can enter a known piece weight and begin counting without sampling.
This can also be used with the tare function active. After you have set the piece
weight, place the item to be tared on the scale, press the Tare key and
continue with counting as described below.
Follow these steps:
1. Turn the scale on and zero the display, if necessary, using the Zero key.
Be sure the scale is displaying weight in your preferred unit of measure.
Change it using the Units key, if necessary.
2. Press the Pcwt key…
PC.t
is displayed in the COUNT window and zeroes are displayed in
the WEIGHT and PIECE WEIGHT windows.
3. There is a decimal point already in the PIECE WEIGHT window. Key in
the known piece weight, in decimal pound or grams, using the numeric
keypad so that the piece weight in the PIECE WEIGHT window is
correct, then press the Enter key to accept this piece weight. (If you
make an error in keying in the number, press the Clear key to clear the
number and re-key the correct number.)
The counting mode activates using the entered piece weight.