2 grating, 7 electrical connection, Danger – CASO Germany HCMG25 User Manual

Page 54

Advertising
background image

caso HCMG 25

54

11.6.2

Grating

• Place the grating on the glass turntable.

► Use the grating only for grilling, convection and combination operation C3.

11.7 Electrical connection

DANGER

► Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the appliance.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not

properly installed and grounded.

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:

• Before connecting the device, compare the connection data (voltage and frequency) on

the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.

• The electrical outlet must be protected by a 16A safety cut-out switch.

• The connection between the device and the electrical network may employ a 3 meter

long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.

• Make sure that the power cable is undamaged and has not been installed under the

oven or over hot or sharp surfaces.

• This appliance must be electrically grounded. In case of a short circuit grounding will

protect against electric shocks because the electrical current is diverted through the
grounding lead. The appliance is fitted with an appropriate cable with a ground lead
and a grounded safety plug. The plug must be inserted into a properly installed and
grounded outlet.

• The electrical safety of the device is only guaranteed if the device is connected to a

properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

Advertising