CASO Germany MCG 20 chef - Manual (Page 69)

caso MCG20 Chef 69
14.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
14.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Error code Description
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250°C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme.
Press the Stop button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
14.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program
will not start.
Device door is not closed
► Close device door
Power plug is not plugged in
► Plug in mains plug!
Fuse is not activated
► Activate fuse
The turntable turns
jerkily.
Dirt between the turntable and
the base of cooking camber
► Remove dirt
Dirt on rolling ring
Cooking vessel too large
► Use different cooking
vessel