BoonDocker POLARIS: 2007-10 Dragon Pump Gas - Manual (Page 10)

BoonDocker Performance 1585 Hollipark Dr. Idaho Falls, ID 83401
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10/01/2010 Page 10
Step 7 Install coolant lines for turbocharger
A. Locate the longer water hose and a #4 hose clamp.
This hose will mount on the outside ofThe turbo
and route under the oil tank up to the coolant
reservoir and fasten to the barb as shown. Be
careful when removing and installing the hose on
the reservoir, it is only plastic and can break.
Fasten this connection with a #4 hose clamp.
B. Locate the shorter water hose. This hose will mount on the inside of the turbo and route to
the right side of the throttle bodies. Be sure to keep
this hose away from any sharp or abrasive objects
and any heat sources. Fasten this connection with a
#4 hose clamp. You can zip tie the 2 water lines
together to help secure them in place and it makes
for a cleaner install (see picture). Important: Make
sure not to kink the hose(s), mount them to, or
lay them on any abrasive surface.