Coral Industries Hyaline Swing Door (1/4 Frameless) - 6M0 - Manual (Page 3)

6M0 7/09
Place jambs (B) on sill with short legs against wall and
bottom of jambs resting on sill. If necessary, file sharp
corners on back of jambs to fit contour of your unit.
Align jambs vertically using a level. Mark wall through
prepunched holes. Remove jambs and drill where marked
using 1/8" drill bit.
Reposition jambs on wall and secure using 8A x 1 1/4" pan
head screws (L).
Level
Sill A
OUTSIDE OF SHOWER
Jamb B
Contour
as
needed
When anchors (N) are used holes should be drilled
using 3/16" drill bit.
8A x 1 1/4"
Pan Head Screw L
3 Jambs
(B)
Lay door panel, with hinge door stop attached, on a work
table covered with cardboard or carpet. Position so that
hinge door stop swings up as shown. This will be the
outside surface of your door panel (facing up). Adjust door
on work table so that the opening edge and handle holes
extend past table edge.
Mark center of glass on opening edge of door panel.
Wrap handle vinyl, from magnetic catch kit (R), over edge
of glass. Thinner glass may require the use of two pieces
of vinyl to insure a tight grip between handle and glass.
Hold metal slide for installation later. With a rubber mallet,
tap magnet holder, with magnet attached, onto glass.
Magnet should face inside of shower.
Hinge Door Stop
(Swings toward outside
surface of glass)
Outside surface
of panel
Magnet Holder
with Magnet
(Magnet faces
inside of shower)
R
Center
Handle
Vinyl
OUTSIDE
SURFACE OF
DOOR
5 Push / Pull Handle Kit
(K)
Push / Pull handle kit (K) comes with parts assembled in the
order they will be once installed on glass. Disassemble parts.
Place bushings in holes in glass. Trim as needed so that
bushings are flush with surface of glass. Place one plastic
washer on each connector screw and insert screws (from
inside surface of glass) through bushings in glass.
Place second plastic washer on exposed end of connector
screws on outside surface of glass. Holding exterior handle
in place on outside surface of glass, tighten connector screw
to secure handle.
On inside surface of glass, slip interior handle over connector
screws and tighten with 3/32" allen wrench provided.
Exterior
Handle
Plastic
Washer
Handle
Connector
Screw
Bushing
Plastic
Washer
INSIDE SURFACE OF GLASS
3/32 Allen
Wrench
Interior
Handle
Push/Pull Handle Kit K
4 Magnetic Catch Kit
(R)
Magnet Holder
with Magnet
(Magnet faces
inside of shower)
R