Coral Industries Hyaline Swing Door (1/4 Frameless) - 6M0 - Manual (Page 4)

6M0 7/09
Position hinge door stop, which is attached to door
panel, over jamb on opposite side from magnetic
door stop. For safety purposes, door should be
installed to open out from shower.
7 Hinge Door Stop
and
Door Panel
Sill
A
OUTSIDE OF SHOWER
B
Hinge Door Stop
Jamb
Door Panel
Sill A
OUTSIDE OF
SHOWER
B
Metal
Slide R
Magnetic
Door Stop
Jamb
Vinyl door seal (D), in magnetic door stop (C), must
be removed from channel, trimmed into two pieces
and replaced with metal slide (R) in between vinyl
pieces.
Mark center of magnetic door stop. Remove vinyl door
seal and trim to fill open channel of door stop from sill
to 2" below center mark. Reinsert cut vinyl in channel.
Follow with metal slide and remaining piece of vinyl.
Trim vinyl flush with door stop at top.
Slide magnetic door stop over jamb, with bottom of
door stop seated on sill and vinyl door seal facing
outside of shower. Bump sill slightly toward outside
of shower to accommodate width of magnetic door
stop leg fitting in between jamb and tall edge of sill.
Cut vinyl
door seal to
fill area
between sill
and 2" below
center mark
Vinyl Door Seal
faces outside of
shower D
6 Magnetic Door Stop
(C)
C