Coral Industries 6000 Swing Door/DPNL - 563 - Manual (Page 6)

563-GP 2/06
Adjust side panels, magnetic door stop, and hinge door
stop until magnetic strip aligns properly on door panel
and door closes evenly at top and bottom. Once desired
alignment of parts has been achieved, from inside
shower, drill four evenly spaced holes through legs of
jambs (1/4" from edge) into side panels. Secure
using 8A x 3/8" truss head screws (K).
Secure hinge and magnetic door stops to side panels
in the same manner, by drilling, from inside shower,
four evenly spaced holes (1/4" from edge of door stops)
into side panels. Secure using 8A x 3/8" truss head
screws.
Secure header by drilling, from inside shower, through
header into jambs, hinge and magnetic door stops.
Secure using 8A x 3/8" truss head screws.
When securing door stops and jambs to side
panels, do not drill through front side of panel or
hit glass with drill bit. Glass is seated
approximately 1/2" into channel.
Hinge or
Magnetic
Door Stop
Jamb
INSIDE OF SHOWER
Door
Panel
Header
Side Panel
8A x 3/8"
Truss Head
Screws
K
B
C
1/4"
1/4"
6 Securing Verticals
1/4"
1/4"
Hinge
Door Stop
8A x 3/8 "
Truss Head Screws
K
E
A
Side
Panel
Secure sill by drilling, from outside shower, through
sill into magnetic door stop and hinge stop. Secure
using 8A x 3/8" truss head screw.
OUTSIDE OF SHOWER
Sill
7 Securing Verticals
Magnetic
Door Stop
Side
Panel
Door
Panel
Mount pull handles, from pull handle kit (M), using
6-32 x 1 1/4" pan head screws provided. Screw
heads should be on the inside of shower.
6-32 x 1 1/4" Pan
Head Screw
Interior
Handle
Exterior
Handle
OUTSIDE OF SHOWER
Pull
Handle
Kit
Handle for your door may be pre-installed. If so,
disregard this step and continue installation.
M
8 Pull Handle Kit
(M)