Coral Industries 6000 Swing Door/DPNL - 563 - Manual (Page 7)

563-GP 2/06
Drip rail may be additionally secured
using 8A x 3/8" truss head screws.
When drilling in door panel, make certain
drill does not hit glass. Glass is seated
approximately 1/2" into channel.
Clean bottom channel of door before
mounting drip rail. After mounting, do
not remove or reposition. Allow 72
hours curing time for maximum bond.
From inside shower, measure width of door
panel at bottom. Drip rail (D) should be 1/2"
shorter than door panel width. If longer, cut to
proper length.
For one-piece vinyl drip rail (V667), continue with
next step.
Slide vinyl sweep (F) into slot on back of drip
rail. Trim ends even with edges of drip rail.
Smooth cut end of drip cap fin with a file to
remove sharp point.
Drip Rail Sweep
F
D Drip Rail
Contour
INSIDE
OF SHOWER
Measure
I
D Drip
Rail
INSIDE OF SHOWER
Drip Rail Plug
1/2"
1/4" drop
from
Opening
Side to
Hinge Side
for drainage
Door
Panel
Position drip rail on inside surface of door
panel as described below:
• Side-to-side placement: Edge of drip rail
should be flush with edge of door panel on
hinge side of door.
• Vertical placement: Vinyl sweep should
extend 1/2" below bottom of door panel on
opening side. Angle drip rail so that vinyl
sweep extends 3/4" below bottom of door
panel on hinge side. This will create an 1/4"
slope from opening to hinge side for water
drainage.
Mark position. Remove drip rail from door.
Peel protective cover from tape, and press into
place. Insert drip rail plug (I) into groove of drip
rail on opening side of door.
9a Drip Rail
(D)
9b Drip Rail
(D)
Opening Side
Hinge Side
Drip rail flush
with edge of
Door Panel
F Vinyl Sweep
3/4"
Hinge Side