Coral Industries Style Swing Door/DPNL (1/4 Frameless) - 660 - Manual (Page 4)

660 6/09
Setting blocks (X) are used in sill to provide a resting surface
for panel glass. Place one setting block in sill at edge of wall
jamb. A second setting block should be placed in sill to
support other corner of panel glass once glass is placed in
unit. Measure panel glass and position remaining setting
blocks accordingly.
Place panel glass in wall jamb with bottom of glass resting on
setting blocks in sill and side of glass seated in wall jamb 3/8".
Place remaining jamb (panel jamb) over panel glass with long
legs of jamb fitting over edge of glass 3/8", and bottom of jamb
seated in sill.
Repeat for opposite side.
X Setting
Blocks
OUTSIDE OF
SHOWER
Panel Glass
A Sill
Jamb B
The following instructions call for glass to seat in
verticals 3/8". This distance may be adjusted from
1/4" - 1/2" to accommodate out-of-plumb walls and
allow for a better fit of parts.
5 Setting Blocks
(X)
/ Side Panels
Jamb
B
Setting Blocks
X
Panel Glass
Decide which will be the opening side of your door. Door is
normally installed to open on the side of unit nearest to
showerhead.
Vinyl door seal (F), in magnetic door stop (E), must be
removed from channel, trimmed into two pieces and replaced
with metal slide (from magnetic catch kit (K) or magnetic pull
handle kit (M)) in between vinyl pieces.
Mark center of magnetic door stop. Remove vinyl door seal
and trim to fill open channel of door stop from sill to 2" below
center mark. Reinsert cut vinyl in channel. Follow with metal
slide and remaining piece of vinyl. Trim vinyl flush with door
stop at top.
Slide magnetic door stop over jamb, with bottom of door stop
seated in sill and vinyl door seal facing outside of shower.
B
Jamb
E
Magnetic
Door Stop
OUTSIDE OF
SHOWER
F Vinyl Door Seal
faces outside
of shower
6 Jamb
(B)
/ Magnetic Door Stop
(E)
4b Push / Pull Handle Kit
(J)
Freestyle Series
Push / Pull handle kit (J) comes with parts assembled in the order
they will be once installed on glass. Disassemble parts.
Place bushings in holes in glass. Trim as needed so that bushings
are flush with surface of glass. Place one plastic washer on each
connector screw and insert screws (from inside surface of glass)
through bushings in glass.
Place second plastic washer on exposed end of connector screws
on outside surface of glass. Holding exterior handle in place on
outside surface of glass, tighten connector screw to secure handle.
On inside surface of glass, slip interior handle over connector
screws and tighten with 3/32" allen wrench.
Exterior
Handle
Plastic
Washer
Handle
Connector
Screw
Bushing
Plastic
Washer
INSIDE OF SHOWER
3/32 Allen
Wrench
Interior
Handle
Push/Pull Handle Kit J
Sill
K M
Jamb
B
B
Cut vinyl door seal
to fill area between
sill and 2” below
center mark.
Jamb
A
Metal Slide
Jamb
B
Jamb
B
Jamb
B Panel Glass
OVERHEAD VIEW
Showerhead
Door Normal
opening side
Panel Panel
Setting Blocks
X