Coral Industries 6000 Swing Door/ILP - 063 - Manual (Page 4)

063-GP 11/06
Due to the manufacturing process, there may be
rack marks present at one end of your sill and
header. Sill and header must be trimmed to fit your
individual opening. When cutting sill and header,
make certain to trim off end with rack marks.
Measure opening at threshold of shower and cut sill (A)
to that measurement. If necessary for a smooth fit, file
sharp corners of sill to fit curved corners of your unit.
Mark centerline on threshold. Position sill on centerline
with tall edge of sill toward outside of shower. Tape sill
to threshold with masking tape to hold in place while
positioning jambs.
Place jamb (B) on sill with short legs against wall. If
necessary for a smooth fit, file back edge (short legs) of
jamb to fit contour of your unit.
Align jamb vertically on wall using a level. Mark wall
through prepunched holes and remove jamb. Drill
where marked using 1/8" drill bit. Repeat for remaining
jamb on opposite wall.
Reposition jambs and mount to wall using 8A x 1" pan
head screws (J).
Sill A
Sill A
B
Jamb
Level
File to fit
contour of
your unit
as needed
Masking
Tape
Measure
When anchors (L) are used, holes should be drilled
using 3/16" drill bit. (Use masonry bit for tile.)
File sharp
corners as
necessary to
fit contour of
your unit.
OUTSIDE
OF SHOWER
OUTSIDE OF
SHOWER
2 Jambs
(B)
1 Sill
(A)
J 8A x 1" Pan
Head Screw
Threshold
Centerline
Centerline
Decide on the arrangement of your door panel and
in-line panel. Panel may be installed on right or left side
of door. Door is nomally installed to open on side
nearest to showerhead.
Insert panel into wall jamb with bottom of panel resting
on sill. Only position panel at this time. Parts will be
drilled and secured after door is in place and
adjustments have been made for proper alignment.
Slide double channel (D) over in-line panel with bottom
resting on sill.
Jamb
D
Double
Channel
B
OUTSIDE OF SHOWER
3 In-Line Panel / Double Channel
(D)
Panel may be
installed on right or
left side of door.
INSIDE OF
SHOWER
INSIDE OF
SHOWER
Door
Panel
In-Line
Panel
In-Line
Panel
Door
Panel
In-Line Panel
Masking
Tape