Coral Industries Provincial Prestige Swing Door - 4PJ - Manual (Page 3)

4PJ 8/02
Position hinge door stop, which is attached
to door panel, into jamb on opposite side
from magnetic door stop. For safety
purposes, door should be installed to open
out from shower.
Slide magnetic strip (D) into slot on magnetic
door stop (C). Trim ends even with door stop
using scissors.
Choose side onto which magnetic door stop will
be attached. Door stop is normally mounted in
jamb nearest to showerhead. Slide magnetic
door stop into jamb with magnetic strip facing
outside of shower.
INSIDE
OF
SHOWER
INSIDE
OF
SHOWER
Door Door
Magnetic Strip
(facing outside of shower)
B
Magnetic
Door Stop
Jamb
C
D
Door may be installed to hinge from either wall jamb.
OUTSIDE OF SHOWER
Hinge Door Stop
(attached to door)
Wall
OUTSIDE OF SHOWER
Jamb B
Door
Panel
3
4
If magnetic strips do not seal tightly,
reverse polarity by removing strip
from door stop and replacing it with
the previous top end to the bottom
end.
On units with clear, painted glass, the painted surface of glass faces outside of shower.
On units with tinted, painted glass, the painted surface of glass faces inside of shower.
Adjust magnetic and hinge door stops until
magnetic strip aligns properly on door panel
and door closes evenly at top and bottom.
Once desired alignment of parts has been
achieved, from inside of shower, drill four
evenly spaced holes through leg of jambs
(1/4" from edge) into hinge and magnetic
door stops. Secure using 8A x 3/8" truss
head screws (H).
Jamb B
INSIDE OF SHOWER
Door Panel
Hinge Door Stop
(attached to door)
Magnetic
Door Stop
C
8A x 3/8 "
Truss Head Screws
H
1/4"
1/4"
5
When securing door stops
to jambs, do not drill
through front side of jamb.
Jamb B