Coral Industries Provincial Prestige Swing Door - 4PJ - Manual (Page 4)

4PJ 8/02
The use of a caulking compound
will assure a water-tight seal of your
enclosure. Apply caulk along
outside edge of enclosure where
metal and shower meet,
especially where sill meets
threshold. If desired, caulk inside of enclosure
where jambs meet walls.
Caulk joint on sill where magnetic door stop and
sill meet. On opposite side, caulk where hinge
door stop and sill meet.
OUTSIDE OF SHOWER OUTSIDE OF SHOWER
Jamb
B
Hinge Door
Stop
Caulk
C
Magnetic
Door Stop
Door
Panel
Sill A
Caulk
6
9
7
8
Drip rail may be additionally secured by drilling with 1/8" drill bit through drip rail into bottom channel. Attach using
8A x 3/8" truss head screws. When drilling in door panel, make sure drill does not hit glass. Glass is seated
approximately 1/2" into channel.
With door in closed position, place drip rail on bottom channel of
door on inside of shower. Position so that bottom edge of
sweep extends approximately 1/2" below bottom of door.
Mark location for drip rail, peel protective cover from tape (K) and
press into place.
Insert drip rail plug (P) into groove of drip cap on opening side of
door.
INSIDE
Measure
Make certain that bottom channel of door is clean and
dry before mounting drip rail. After mounting, drip rail
should not be removed or repositioned. Adhesive on
tape needs 72 hours curing time for maximum bond.
P
Drip Rail
Tape
E
K
INSIDE OF SHOWER
Drip Rail Plug
1/2"
Sweep extends
1/2" below
bottom channel.
Door
Panel
Drip
Rail
Drip Rail
Sweep
L
E Drip Rail
Contour
From inside shower, measure width of door panel at
bottom. Drip rail (E) should be 1/2" shorter than door
width. If longer, cut to proper length.
Slide vinyl sweep (L) into slot on back of drip rail.
Trim ends even with edges of drip rail.
Smooth cut end of drip rail fin with a file to remove sharp point.
Sill
A
Connector Screw
with Washer
J
INSIDE OF SHOWER
Exterior
Handle
J
Interior
Handle
Push / pull handle kit (J) comes with parts
assembled in the order they will be once installed
on glass. Loosen allen screws using allen wrench
(I) on interior handle to dissasemble parts.
Place bushings in holes of glass. Trim so that
bushings are flush with glass surface. Place one washer on
each connector screw. From inside surface of glass, insert
connector screw through hole, backing with another washer
on outside of glass. Hold exterior handle in place on outside
of glass and secure by tightening connector screws.
On inside of glass, slip interior handle over connector screws.
Secure in place by tightening allen screws on interior handle.
Bushing
Washer
Allen Screw