Coral Industries Style Swing Door (1/4 Frameless) - 620 - Manual (Page 4)

620 7/09
Position hinge door stop, which is attached to door panel,
over jamb on opposite side from magnetic door stop. For
safety purposes, door should be installed to open out from
shower.
6 Hinge Door Stop
and
Door Panel
Sill
A
OUTSIDE OF SHOWER
B
Hinge Door
Stop
Jamb
Door Panel
4b Push / Pull Handle Kit
(J)
Freestyle Series
Push / Pull handle kit (J) comes with parts assembled in the
order they will be once installed on glass. Disassemble parts.
Place bushings in holes in glass. Trim as needed so that
bushings are flush with surface of glass. Place one plastic
washer on each connector screw and insert screws (from
inside surface of glass) through bushings in glass.
Place second plastic washer on exposed end of connector
screws on outside surface of glass. Holding exterior handle
in place on outside surface of glass, tighten connector screw
to secure handle.
On inside surface of glass, slip interior handle over connector
screws and tighten with 3/32" allen wrench.
Exterior
Handle
Plastic
Washer
Handle
Connector
Screw
Bushing
Plastic
Washer
INSIDE OF SHOWER
3/32 Allen
Wrench
Interior
Handle
Push/Pull Handle Kit J
5 Magnetic Door Stop
(C)
Sill A
OUTSIDE OF
SHOWER
B
Magnetic
Door
Stop
C
Jamb
Vinyl door seal (D), in magnetic door stop (C), must be
removed from channel, trimmed into two pieces and
replaced with metal slide (from magnetic catch kit (K) or
magnetic pull handle kit (M)) in between vinyl pieces.
Mark center of magnetic door stop. Remove vinyl door seal
and trim to fill open channel of door stop from sill to 2" below
center mark. Reinsert cut vinyl in channel. Follow with
metal slide and remaining piece of vinyl. Trim vinyl flush
with door stop at top.
Slide magnetic door stop over jamb, with bottom of door
stop seated on sill and vinyl door seal facing outside of
shower. Bump sill slightly toward outside of shower to
accommodate width of magnetic door stop leg fitting in
between jamb and tall edge of sill.
Cut vinyl
door seal to
fill area
between sill
and 2" below
center mark
Vinyl Door
Seal
faces outside
of shower D
K
Metal Slide
M