Coral Industries Style Swing Door (1/4 Frameless) - 620 - Manual (Page 5)

620 7/09
Measure width of door glass at bottom.
Trim vinyl drip sweep (E) to door glass width minus
1/8". Trim only from door hinging end of drip sweep.
Contour cut end of drip sweep fin to remove sharp point.
Press drip sweep onto bottom edge of door glass with
fin facing inside of shower and edge of drip sweep flush
with edge of glass on hinging side of door.
E
Vinyl Drip Sweep
Fin faces inside
of shower.
OUTSIDE OF
SHOWER
Drip Sweep
length =
Door Width
minus 1/8"
The use of a caulking compound will assure a water-
tight seal of your enclosure. Apply caulk along outside
edge of enclosure where metal and shower meet,
especially where sill meets threshold. If desired, caulk
inside of enclosure where jambs meet walls.
Caulk joint on sill where magnetic door stop and sill
meet. On opposite side, caulk where hinge door stop
and sill meet.
8 Vinyl Drip Sweep
(E)
9 Caulking
Check alignment of door and magnetic door stop.
Adjust as needed so that door closes evenly, there is
an even reveal of space at bottom of door, and magnetic
slide aligns with handle magnet.
Once desired alignment of parts has been achieved,
secure parts together, from inside of shower, using
five 8A x 3/8" pan head screws (N) on each side. Attach
door stops to jambs at top and bottom, then evenly
space remaining screws.
When securing door stops to jambs, do not drill
through front side of jamb.
7 Securing Verticals
INSIDE OF
SHOWER
Magnetic
Door Stop
and Jamb
8A x 3/8"
Pan Head Screws
N
Check for even
reveal of space at
bottom of door glass
Check alignment
at magnet
Hinge Door Stop
(attached to door)
and Jamb
OUTSIDE OF SHOWER
Caulk
Door
Panel
Hinge Door
Stop
Sill
Magnetic
Door Stop
Sill
E
Caulk
Caulk
Caulk