Dynojet 250ix: Pit Installation Guide - Manual (Page 56)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-34
5 Remove the control panel rear cover.
5a
Remove the two nuts from the top of the cover and set aside.
5b Remove the screw on the top of the cover and set aside.
5c Remove the screw on the side of the cover and set aside.
5d Remove the four screws on the back of the cover and set aside.
5e Remove the control panel rear cover and set aside.
Figure 2-25: Remove the Control Panel Rear Cover
CP010
top nuts
side screw
rear screws
top screw