Dynojet 250iX: Upgrade Installation Guide User Manual
Page 29
M O D E L 2 0 0 I X / 2 5 0 I X U P G R A D E
Trike Carriage Adapter Installation
Version 1
Model 200iX/250iX Upgrade Installation Guide
1-21
R
EMOVING
THE
C
ARRIAGE
S
CREW
AND
C
ARRIAGE
The monitor stand and high pressure blowers are not shown for clarity.
If the carriage is not installed, skip to “Installing the Trike Carriage Adapter Assembly”
on page 1-23.
1
Remove the four 1/4-20 x 1/2-inch button-head screws securing the bearing
bracket and set aside.
2
Using the hand crank, or the control panel to run the power carriage, run the
carriage screw out of the carriage assembly and set aside.
3
Slide the carriage assembly towards the rear of the dyno. Remove the carriage
assembly and set aside.
Figure 1-17: Removing the Carriage Screw and Carriage
carriage assembly
carriage screw
bearing bracket