Dynojet 250iX: Upgrade Installation Guide - Manual (Page 32)

Model 200iX/250iX Upgrade Installation Guide
C H A P T E R 1
Trike Carriage Adapter Installation
1-24
I NSTALLING THE C ARRIAGE A SSEMBLY
1 Starting from the back of the dyno, slide the carriage under the carriage clamps.
2 Slide the carriage screw and the bearing bracket toward the nut block until the
carriage screw is touching the nut block.
3 Using the hand crank, or the control panel to run the power carriage, run the
carriage screw through the nut block and into the screw support bracket on the
carriage assembly.
4 Secure the bearing bracket to the carriage assembly using the four
1/4-20 x 1/2-inch button-head screws removed earlier.
Figure 1-20: Installing the Carriage Assembly